Faber Cement Remover

• Water based detergent suitable for removing cement and grout residue from tiles

• A heavy duty acidic cleaner suitable for post construction deep cleaning projects

• It fully removes cement residue, grout residue, glues, plaster, filler, paints, sealer

• The product can be safely used on all types of surfaces that are not acid sensitive

• It works very quickly and it fully removes even the worst types of cement residue

• The new Faber Cement Remover also removes mineral efflorescences from tiles

• A concentrated formula that requires dilution before use | Pre-testing is essential

• Compatible with terracotta, porcelain, ceramic, quartz, granite, natural stones, etc

• The product can also be successfully used for deep cleaning badly affected floors

• It can be used in conjunction with a spray system, a mop or a scrubber machine

Faber Cement Remover | Why Use It

The new Faber Cement Remover is a professional cement residue remover that provides outstanding results and it works where other cleaning products have failed. Removing badly impregnated cement, mortar or grout residue from all kinds of surfaces is nearly impossible without the use of the new Faber Cement Remover. This product has saved many tilers from losing their income and has also saved many DIY tile fitters from days of work and scrubbing that in some cases can end up with permanent damage to the surface.

Faber Cement Remover | Where To Use It

Use the new Faber Cement Remover to remove all kinds of post building residue from terracotta tiles, cotto tiles, ceramic tiles, porcelain tiles, quartz tiles, natural stone tiles, concrete tiles, granite tiles and clinker. The new Faber Cement Remover can be used successfully for all kinds of commercial and residential tile cleaning projects. It can also be used for indoor and outdoor tile cleaning projects. Its main job is to remove grout and cement residue from a number of wall and floor tiles but it can also be used to deep clean very neglected floor tiles that are full of ingrained minerals or all kinds of dirt.

Faber Cement Remover | How To Use

The most essential thing while using the new Faber Cement Remover is to make sure that the surface is actually compatible with the product. Pre-testing in a less visible area is essential. Before using the product, the user has to assess the project difficulties and decide on the spot what strength is the most suitable. The product has to be diluted before use. The dilution rate can vary from 1 to 1, 1 to 2 or 1 to 3. The maximum dilution rate is 1 to 3 and it should only be used while dealing with light residues. The maximum dilution rate of 1 to 1 should be used in the cases of heavy duty cleaning projects.

1. Apply the product to the affected area.

2. Allow direct contact for 5-10 minutes.

3. Light scrub with a catering scourer.

4. Rinse off the waste or wipe the waste.

***Do not use steel or copper scourers to scrub sensitive tiles. Do not use wire brushes. Do not use scrapers or blades to scrub surfaces***

Faber Cement Remover | Recommendations

Do not use the new Faber Cement Remover without hand protection. Do not mix up the product with any other types of cleaning products to avoid unwanted reactions. Do not use it on any other types of surface other than tiles. Avoid drips or leaks. Store the product in a cool, safe place away from direct sunlight and out of reach of children Do not use the product undiluted to avoid burning the surface. All tools and mops used to apply the new Faber Cement Remover should be disposed of after use.

Faber Cement Remover